Tips for Navigating Bends Safely
Curbing is one of the car driving maneuvers that must be mastered well. There are quite a lot of moments through corners. If you don't understand how to pass safely, the risk of an accident will increase.
Curbs are often prone to accidents. Moreover, if the road conditions are slippery due to the presence of water on the road surface.
When the road is wet, the tire's traction can decrease, so the possibility of skidding can occur. At that time, various disturbances such as oversteer and understeer could potentially be experienced.
Therefore, drivers must master the technique of passing corners safely. Want to know how? The following are steps that can be taken.
Decrease Speed
This is the main principle in passing corners safely. Immediately reduce vehicle speed when cornering. This is important because good traction is needed to keep the car's speed under control.
There is no definite speed limit required. Drivers only need to measure their own vehicle control capabilities. If you find it more difficult to control the car at a certain speed limit, immediately reduce the speed. This will make it easier to control the vehicle.
However, don't press the brake pedal too deeply. This can actually reduce vehicle traction. It's better to brake appropriately. At the same time, the driver remains prepared. This step is an anticipation when there are conditions that require the driver to reduce speed, such as a vehicle in front or passing it from the opposite direction.
Then, after the speed has dropped, press the gas pedal when the car is about to exit the corner. The car will pass the corner safely.
Arrange Well
Also make sure to take good stances before going around corners. If you see a bend ahead, the driver should prepare himself by positioning the car so that it is ready to corner.
So, how do you prepare? The out to out principle can be used as a guide in making the correct stance.
The implementation is to position the car slightly in the opposite direction of the corner. For example, if you want to turn left, then before entering the corner, the car must be positioned slightly to the right.
After that, the new car moves to the left at a reduced speed. After passing the corner, the speed is increased.
A similar principle can be applied when turning to the right. This will ensure the car is in the right position when going through the corner.
Control the Car Steering Wheel
Complete everything with good steering control. Maximum steering control. Direct the car so that it stays in the right lane when cornering.
How much you turn the steering wheel really depends on the condition of the corner. So, there is no size that can be used as a definite benchmark. The driver only needs to estimate it as when controlling the car in a normal situation.
If the steering wheel is under control, the process of going through corners will be smooth. Security will be obtained.
Increase caution when roads are wet
To negotiate corners safely, high alertness is absolutely necessary. However, when driving on wet roads, the level must be increased. This is because roads that are flooded with water are prone to triggering aquaplaning.
When there is water on the road surface, the tires do not tread optimally. Therefore, tires have a special tread design to remove water so that the tire surface is in contact with the road.
If the tire condition is bad, then this process does not occur. Aquaplaning may occur. Especially in wet corners. Therefore, vigilance needs to be increased when roads are flooded with water.
Those are various tips for passing corners safely. Drivers must apply it every time they take a corner. However, also pay attention to the condition of the tires to increase safety.
Bad tire conditions such as bald and torn will reduce the tire's ability to tread on the road. The traction that is important for passing corners safely will not be obtained.
Therefore, replace the tires with new tires if they are running low. Driving safety will increase, including when going through corners.